CAD Naming Standands

 

FOLDERNAME.PARTNAME.length.modifier.REV-[X]

Where:

                  FOLDERNAME = the folder it is saved under on the Robotics Drive

                  PARTNAME = what the part is commonly called around STEMpunk

                  length = the length/diameter of the part in question. May not be used every time

                  modifer = ued if a part is similar to a different part (example 3) 

                  rev = used when a custom part goes through changes. Use capital numbers starting from           A to ZZ. [rev only used on custom parts, or modified downloaded parts] (example 4)

 

 

EXAMPLE 1:

                  If you want to save an omni wheel used on the drive platform that has a 6in diameter it              would be called:

                  DRIVESYSTEM.OMNIWHEEL.6IN

EXAMPLE 2:

                  If there is a 31in piece of HT beam used on the frame:

DRIVESYSTEM.HTBEAM.31IN

EXAMPLE 3:

                  If it is modified for a certain use, ie; added holes to support wheels

                  DRIVESYSTEM.HTBEAM.31IN.wheelholes.REV-A

EXAMPLE 4:

                  FRIZBEEPICKUP.COLLECTIONPAN.REV-C

                  No length is used because this piece probably won't have a deffinate shape. The [C]     show this piece is in the 3rd iteration (A --> B --> C)